Attic insulation in Jerome ID - an even layer over every inch of your ceiling
Hot upstairs, drafty bedrooms or a power bill that keeps climbing? We check the attic first, then insulate it evenly over the whole ceiling.
What attic insulation should do for your houseand the work that comes first
If the upstairs bakes in summer, the room over the garage never warms up or the power bill keeps climbing, the attic is usually the first place to look. Attic insulation is the layer over your ceiling, and with the air leaks sealed it can bring heating and cooling costs down.
Good attic insulation in Jerome, ID starts with a look, because new material over a roof leak or old wiring just hides the problem. Federal energy guidance runs the job in order, with gas appliances venting safely and fresh indoor air first, then attic venting, then air sealing, which means closing gaps around lights, pipes and the hatch, and insulation last. We work in that order.
Price moves with the attic's size, the inches already up there, the material, how much sealing it needs and whether anything has to come out first, and the schedule turns on the same list plus the permit question. Your estimate puts all of it in writing, in order. If you've got cold floors too, our home insulation work covers the rest of the house.
You'll know what's in your attic and what it needs, in the right order, before any work starts, so call us at (208) 544-9045.
Attic insulation for the attic you have
Most attics get blown-in insulation, which is loose fill sent up through a hose, but what we do first depends on what's already up there and where your ducts run.
Topping up a dry layer
If the old insulation is dry and clean, we seal the gaps through it and blow new fill over the top instead of tearing it out.
Pulling out a bad layer
Insulation that got soaked or filled with droppings comes out first, because covering it leaves the smell and the moisture right where they were.
Foam where the ducts run
Spray foam costs more but seals air as it insulates, which earns its keep when your ductwork lives up there. Otherwise, sealing the gaps and topping up with loose fill usually wins.
Attic and air sealing work done in orderby Steady Jerome Spray Foam Insulation
I'd rather you understand your attic than take my word for it, so we walk you through what's up there and why before we touch anything.
You deal with the owner
I come out myself to look at your attic, answer your questions and write the estimate, and our own installers do the work.
Back in the trade since 2021
I ran insulation jobs years ago, left the trade, and came back in 2021 because I missed the work and knew what a careful job does for a house.
Licensed, insured and easy to check
We're licensed and insured. Idaho's contractor rules reach any job over $2,000 in materials and labor, so it's fair to ask any bidder to show you theirs.
Edges as deep as the middle
Plenty of attics get piled deep in the middle and thin at the eaves, which is backward, so our installers carry the layer all the way to the edges.
You'll be able to judge the work
We explain what we find and why, so you can judge our work and the next contractor's too. Satisfaction guaranteed.
Get your attic checked and pricedin Jerome and the cities nearby
Tell us your attic's rough size in square feet and whether there's old insulation or a bath fan venting up there. We reply within one business day to set up a free estimate at your house, with no obligation.
How an attic job runsfrom your call to the walkthrough
The plan you get with the estimate is the list we work from, top to bottom, so you know what comes next and why at every step.
Call or send a note
Call (208) 544-9045 or use the form, tell us what you're noticing in the house, and we'll get back to you to set up a visit.
We look at it together
I go up into the attic, take photos and show you what's there, then write a plan that puts anything needing a fix at the top of the list.
Fixes and the permit question
Once you say yes, we sort out the permit question with the right office, and anything flagged on the plan gets handled before insulation goes in.
Sealing, baffles, then insulation
Our installers seal the gaps and set baffles at the eave vents, which are chutes that keep the attic breathing, then blow in the new layer evenly across the ceiling.
Cleanup and walkthrough
We clean up, then I check the work and walk the finished attic with you, so you can see the depth, the baffles and the sealed gaps yourself.
Attic insulation questions
How much does attic insulation cost in Jerome, ID?
Insulation work in nearby Twin Falls usually runs about $1 to $5 per square foot, and that's general pricing for the area, not our quote. Where your attic lands depends on what the check turns up, and the on-site estimate gives you our number in a written plan.
How do I know if my attic needs work before insulating?
Hold off if the attic has active knob and tube wiring, which is the old wiring strung on porcelain knobs, or vermiculite, a bathroom fan venting into it, a leaking roof, or if the house has an unvented kerosene heater or gas fireplace, because federal energy guidance says those get handled first. Vermiculite looks like pebbles, usually gray-brown or silver-gold, and it should be treated as if it contains asbestos, so leave it undisturbed and have a trained professional remove it if it has to go. We look for all of this on the first visit, before anything else gets planned.
What is the best way to insulate an attic, blown cellulose or fiberglass?
Neither wins in every attic, because blown cellulose packs more insulating value into each inch, flows around obstructions and seals some air, while blown fiberglass settles less and holds its depth. The choice comes down to a fuller, tighter fill versus a layer that keeps its depth. We'll walk you through both in your own attic and tell you which one suits it.
Do I need a permit for attic insulation in Jerome?
It might, and the published lists don't settle it for attic insulation, so we ask before work starts. The City of Jerome Building Safety Department issues permits for residential projects, and Jerome County's building office, which covers unincorporated areas and cities that have an agreement with it for building code services, lists remodels and additions but not attic insulation. We check with the office that covers your address, and if a permit is needed, we handle the application and set up the inspections.
What should I ask an attic insulation contractor before I hire one?
Ask whether the bid seals air leaks before adding insulation, since that order gets the most energy savings, and whether it puts baffles and wind dams in every rafter bay that has a soffit vent, the vent under your eaves, to keep the layer even. On a home contract over $2,000, Idaho requires a general contractor to give you a disclosure statement first, and you sign a receipt for it. That statement says you can ask for proof of liability and workers' compensation insurance, and for lien waivers from subcontractors at your reasonable expense.
Do we have to leave the house while the attic gets insulated?
With blown cellulose or fiberglass, usually not, since the work happens up in the attic, though we'll ask you to keep kids and pets clear of the hatch and the hose. Spray foam is different because it has a re-entry time, the wait before you can come back inside, and we go by the foam maker's instructions and tell you that time before we start.
Attic insulation around Jerome, ID
We're based in Jerome and also work in Twin Falls, Kimberly and other cities nearby, where we see plenty of older attics with thin or settled insulation. Pick your area below or give us a call.
Book an attic insulation check in Jeromebefore you sign anything
If you're holding another bid, bring it, and I'll show you in your own attic what it covers and what it leaves out. Call (208) 544-9045 or use the form to book a look.